Method

1, Before treatment

How the surface looks before getting treated.

2, Applying primer

Remove dust and dregs, and apply cement primer.

3, Filling with repair material

Knead Repair Resin to a slightly hard consistency, then apply with a trowel. *Use your fingertip to apply for the best result.

4, Cover the chip

Since it’s a material to be cut and shaped, apply a little higher than the surface, and wait for it to harden. *It should start to harden within 2-3 minutes in the summer.

5, Shaping

Use a trowel or a scraper to cut a little at a time. *Start cutting before the material dries thoroughly.

6, Drying and hardening

Once Repair Resin is thoroughly dry, apply C Repair Lining if needed. *C Repair Lining isn’t applied in this photo.

7, Spraying

Spray a small amount of C Repair Color to see the color. Wait until dry, then add as per need.

8, Finished look

The process is completed when it looks natural and matches its surroundings. Add patterns if needed. *Patterns aren’t added in this photo.

Tools to prepare

  • Trowel(1~2mm)
  • Metal trowel
  • Bowl
  • Scraper
  • Waterproof sandpaper #600
  • Wire brush
  • Small bucket
  • Brush
  • Wiping cloth
  • Wagner FLEXIO 570
  • Air compressor
  • Air hose
  • Air gun
  • Pattern Pad
  • Gas torch
  • Electric blower
  • Grinder
  • Level Grinding Wheel #36/#80

Materials to prepare

Notes

  • All Repair Resin products are pre-mixed and only use water for kneading. Please note that the curing time and color may differ if any adhesives are mixed.
  • Once it’s mixed with water, please use it all. Re-watering or kneading once curing has started may cause cracks and poor adhesion.
  • Because it’s cement-based, it is subject to weathering and moisture absorption. Please store with care and use as soon as possible. (The 5kg inner bag is heat-sealed to improve shelf life. Please use the rubber band attached for sealing any leftover products.)
  • When repairing, remove the excess unevenness of the surface beforehand with a hammer, chisel, scraper, etc., and clean it. If the mold releasing agent remains on the surface, it’ll peel off easily. Use a brush to scrub the surface and moisten it with water for the best results.
  • Please be careful when handling a scraper or a metal trowel, as they may cut your hand.
  • Please read the instructions and notes of C Repair Lining and C Repair Color.
  • After adding the Mixing Liquid into C Repair Color, please use it all within 24 hours.
  • Cover and protect the area where you don’t wish to spray paint beforehand.
  • If it adheres to any unwanted area, wipe it off with a wet wiping cloth.
  • Please make sure to mix C Repair Color thoroughly before use. If it’s not fully mixed, it may cause unevenness.
  • Spray C Repair Color little at a time in thin layers. If you spray too thickly at once, it may drop, and the finished look will not look as good. Please repeat the process of “Spray → Dry → Spray” until the surface is fully covered.
  • When adding patterns, tap lightly and inconsistently according to the surrounding patterns.
https://youtu.be/WWhZb5OsoLA