Method

1, Before pin holes treatment

Knead Repair Resin to a slightly stiff consistency.

2, Filling the repair material

Fill in the pin holes with Repair Resin, let it overhang and dry as it is.

3, Scraping

When Repair Resin is half dried, scrape off the overhanging bits.

OLYMPUS DIGITAL CAMERA

4, Surface treatment

When it’s completely dried, rub it with sandpaper to match the surroundings.

5, Finished look

It’s all completed.

Tools to prepare

  • Trowl(1~2mm)
  • Bowl
  • Scraper
  • Waterproof Sandpaper #6
  • Small bucket
  • Brush

Materials to prepare

Notes

  • All Repair Resin products are pre-mixed and only use water for kneading. Please note that the curing time and color may differ if any adhesives are mixed.
  • Once it’s mixed with water, please use it all. Re-watering or kneading once curing has started may cause cracks and poor adhesion.
  • Because it’s cement-based, it is subject to weathering and moisture absorption. Please store with care and use as soon as possible. (The 5kg inner bag is heat-sealed to improve shelf life. Please use the rubber band attached for sealing any leftover products.)
  • When repairing, remove the excess unevenness of the surface beforehand with a hammer, chisel, scraper, etc., and clean it. If the mold releasing agent remains on the surface, it’ll peel off easily. Use a brush to scrub the surface and moisten it with water for the best results.
  • Please be careful when handling a scraper or a metal trowel, as they may cut your hand.
  • Please read the instructions and notes of C Repair Lining and C Repair Color.
  • After adding the Mixing Liquid into C Repair Color, please use it all within 24 hours.
  • Cover and protect the area where you don’t wish to spray paint beforehand.
  • If it adheres to any unwanted area, wipe it off with a wet wiping cloth.
  • Please make sure to mix C Repair Color thoroughly before use. If it’s not fully mixed, it may cause unevenness.
  • Spray C Repair Color little at a time in thin layers. If you spray too thickly at once, it may drop, and the finished look will not look as good. Please repeat the process of “Spray → Dry → Spray” until the surface is fully covered.
  • When adding patterns, tap lightly and inconsistently according to the surrounding patterns.
https://youtu.be/QQw0clq3ys8